Init fork from Stuart Robinson's repo

examples/SX128x_examples/Basics/1_LED_Blink/1_LED_Blink.ino

@@ -0,0 +1,61 @@
+/*******************************************************************************************************
+  Programs for Arduino - Copyright of the author Stuart Robinson - 06/02/20
+
+  This programs is supplied as is, it is up to the user of the program to decide if the programs are
+  suitable for the intended purpose and free from errors.
+*******************************************************************************************************/
+
+/*******************************************************************************************************
+  Program Operation - This program blinks an LED connected the pin number defined below. The pin 13 LED,
+  fitted to some Arduinos is blinked as well. The blinks should be close to one per second. messages are
+  sent to the Serial Monitor also.
+
+  Serial monitor baud rate is set at 9600.
+*******************************************************************************************************/
+
+#define LED1 8                                 //pin number for LED, set logic level high for on
+
+uint16_t seconds;                              //used to display time elapsed on Serial Monitor
+
+void loop()
+{
+  Serial.print(seconds);
+  Serial.println(F(" Seconds"));               //this message should print on console at close to once per second
+  seconds++;
+  digitalWrite(LED1, HIGH);
+  digitalWrite(13, HIGH);
+  delay(100);
+  digitalWrite(LED1, LOW);
+  digitalWrite(13, LOW);
+  delay(890);                                  //should give approx 1 second flash
+}
+
+
+void led_Flash(uint16_t flashes, uint16_t delaymS)
+{
+  //general purpose routine for flashing LED as indicator
+  uint16_t index;
+
+  for (index = 1; index <= flashes; index++)
+  {
+    digitalWrite(LED1, HIGH);                  //LED on
+    digitalWrite(13, HIGH);                    //Arduino board LED on
+    delay(delaymS);
+    digitalWrite(LED1, LOW);                   //LED off
+    digitalWrite(13, LOW);                     //Arduino board LED off
+    delay(delaymS);
+  }
+}
+
+
+void setup()
+{
+  pinMode(LED1, OUTPUT);                       //setup pin as output for indicator LED
+  pinMode(13, OUTPUT);                         //setup pin as output for some Arduino boards that include an LED on pin 13
+  led_Flash(2, 125);                           //two quick LED flashes to indicate program start
+
+  Serial.begin(9600);
+  Serial.println();
+
+  Serial.println(F("1_LED_Blink Starting"));
+}