Init fork from Stuart Robinson's repo

examples/SX128x_examples/Basics/3_LoRa_Transmitter/Settings.h

@@ -0,0 +1,34 @@
+/*******************************************************************************************************
+  Programs for Arduino - Copyright of the author Stuart Robinson - 06/02/20
+
+  This program is supplied as is, it is up to the user of the program to decide if the program is
+  suitable for the intended purpose and free from errors.
+*******************************************************************************************************/
+
+//*******  Setup hardware pin definitions here ! ***************
+
+//These are the pin definitions for one of my own boards, the Easy Pro Mini,
+//be sure to change the definitions to match your own setup.
+
+#define NSS 10
+#define RFBUSY 7
+#define NRESET 9
+#define LED1 8
+#define DIO1 3
+#define RX_EN -1                                //pin for RX enable, used on some SX1280 devices, set to -1 if not used
+#define TX_EN -1                                //pin for TX enable, used on some SX1280 devices, set to -1 if not used  
+#define BUZZER -1                               //pin for BUZZER, set to -1 if not used 
+
+
+#define LORA_DEVICE DEVICE_SX1280                //we need to define the device we are using  
+
+//LoRa Modem Parameters
+const uint32_t Frequency = 2445000000;           //frequency of transmissions
+const int32_t Offset = 0;                        //offset frequency for calibration purposes
+const uint8_t Bandwidth = LORA_BW_0400;          //LoRa bandwidth
+const uint8_t SpreadingFactor = LORA_SF7;        //LoRa spreading factor
+const uint8_t CodeRate = LORA_CR_4_5;            //LoRa coding rate
+
+const int8_t TXpower = 10;                       //Power for transmissions in dBm
+
+const uint16_t packet_delay = 1000;              //mS delay between packets