Init fork from Stuart Robinson's repo

examples/SX128x_examples/Tracker/23_GPS_Tracker_Transmitter/Settings.h

@@ -0,0 +1,63 @@
+/*******************************************************************************************************
+  Programs for Arduino - Copyright of the author Stuart Robinson - 16/12/19
+
+  This program is supplied as is, it is up to the user of the program to decide if the program is
+  suitable for the intended purpose and free from errors.
+*******************************************************************************************************/
+
+//*******  Setup hardware pin definitions here ! ***************
+
+//These are the pin definitions for one of my own boards, the Easy Pro Mini,
+//be sure to change the definitions to match your own setup.
+
+#define NSS 10                                  //select on LoRa device
+#define NRESET 9                                //reset on LoRa device
+#define RFBUSY 7                                //SX128X busy pin 
+#define DIO1 3                                  //DIO1 on LoRa device, used for RX and TX done
+
+#define GPSPOWER 4                              //Pin that controls power to GPS, set to -1 if not used
+#define GPSONSTATE HIGH                         //logic level to turn GPS on via pin GPSPOWER 
+#define GPSOFFSTATE LOW                         //logic level to turn GPS off via pin GPSPOWER 
+
+#define RXpin A3                                //pin number for GPS RX input into Arduino - TX from GPS
+#define TXpin A2                                //pin number for GPS TX output from Arduino- RX into GPS
+
+#define LED1 8                                  //On board LED, high for on
+#define SupplyAD A7                             //pin for reading supply\battery voltage  
+#define BATVREADON 8                            //turns on battery resistor divider, high for on, -1 if not used
+
+const float ADMultiplier = 10.0;                //multiplier for supply volts calculation
+#define DIODEMV 98                              //mV voltage drop accross diode at approx 8mA
+
+
+#define LORA_DEVICE DEVICE_SX1280    //we need to define the device we are using 
+
+
+
+//*******  Setup LoRa Parameters Here ! ***************
+
+//LoRa Modem Parameters
+const uint32_t Frequency = 2445000000;           //frequency of transmissions
+const int32_t Offset = 0;                        //offset frequency for calibration purposes
+const uint8_t Bandwidth = LORA_BW_0200;          //LoRa bandwidth
+const uint8_t SpreadingFactor = LORA_SF12;       //LoRa spreading factor
+const uint8_t CodeRate = LORA_CR_4_5;            //LoRa coding rate
+
+const int8_t TXpower = 10;                       //Power for transmissions in dBm
+
+#define ThisNode '2'                             //a character that identifies this tracker
+
+//**************************************************************************************************
+// GPS Settings
+//**************************************************************************************************
+
+#define USE_SOFTSERIAL_GPS                       //need to include this if we are using softserial for GPS     
+//#define HardwareSerialPort Serial1             //if using hardware serial enable this define for hardware serial port
+
+#define GPSBaud 9600                             //GPS Baud rate   
+
+#define WaitGPSFixSeconds 30                     //time in seconds to wait for a new GPS fix 
+#define WaitFirstGPSFixSeconds 1800              //time to seconds to wait for the first GPS fix at startup
+#define Sleepsecs 5                              //seconds between transmissions, this delay is used to set overall transmission cycle time
+
+#define echomS 2000                              //number of mS to run GPS echo at startup