/*******************************************************************************************************
  Programs for Arduino - Copyright of the author Stuart Robinson - 19/03/20

  This program is supplied as is, it is up to the user of the program to decide if the program is
  suitable for the intended purpose and free from errors.
*******************************************************************************************************/


//*******  Setup hardware pin definitions here ! ***************

//These are the pin definitions for one of my own boards, the Easy Pro Mini,
//be sure to change the definitions to match your own setup.

const int8_t NSS = 10;                          //select on LoRa device
const int8_t NRESET = 9;                        //reset on LoRa device
const int8_t RFBUSY = 7;                        //RF busy on LoRa device
const int8_t DIO1 = 3;                          //DIO1 on LoRa device, used for RX and TX done
const int8_t LED1 = 8;                          //On board LED, logic high is on

#define LORA_DEVICE DEVICE_SX1280               //this is the device we are using

const int8_t OUTPUT0 = 2;
const int8_t OUTPUT1 = 4;
const int8_t OUTPUT2 = A3;
const int8_t OUTPUT3 = A2;

const uint32_t RXIdentity = 1234554321;         //define an identity number, the receiver must use the same number
//range is 0 to 4294967296



//*******  Setup LoRa Test Parameters Here ! ***************

//LoRa Modem Parameters
#define Frequency 2445000000                     //frequency of transmissions
#define Offset 0                                 //offset frequency for calibration purposes  
#define Bandwidth LORA_BW_0400                   //LoRa bandwidth
#define SpreadingFactor LORA_SF7                 //LoRa spreading factor
#define CodeRate LORA_CR_4_5                     //LoRa coding rate

#define TXpower  10                              //power for transmissions in dBm