/*******************************************************************************************************
  Programs for Arduino - Copyright of the author Stuart Robinson - 06/02/20

  This program is supplied as is, it is up to the user of the program to decide if the program is
  suitable for the intended purpose and free from errors.
*******************************************************************************************************/

//*******  Setup hardware pin definitions here ! ***************

//These are the pin definitions for one of my own boards, the Easy Pro Mini,
//be sure to change the definitions to match your own setup. 

#define NSS 10
#define RFBUSY 7
#define NRESET 9
#define LED1 8
#define DIO1 3
#define RX_EN -1                                //pin for RX enable, used on some SX1280 devices, set to -1 if not used
#define TX_EN -1                                //pin for TX enable, used on some SX1280 devices, set to -1 if not used  
#define BUZZER -1                               //pin for BUZZER, set to -1 if not used 

#define LORA_DEVICE DEVICE_SX1280               //we need to define the device we are using  

//LoRa Modem Parameters
const uint32_t Frequency = 2445000000;           //frequency of transmissions
const int32_t Offset = 0;                        //offset frequency for calibration purposes
const uint8_t Bandwidth = LORA_BW_0400;          //LoRa bandwidth
const uint8_t SpreadingFactor = LORA_SF7;        //LoRa spreading factor
const uint8_t CodeRate = LORA_CR_4_5;            //LoRa coding rate

const int8_t TXpower = 10;                       //Power for transmissions in dBm

const uint16_t packet_delay = 1000;              //mS delay between packets

#define RXBUFFER_SIZE 255                        //RX buffer size