/*******************************************************************************************************
  Programs for Arduino - Copyright of the author Stuart Robinson - 19/03/20

  This program is supplied as is, it is up to the user of the program to decide if the program is
  suitable for the intended purpose and free from errors.
*******************************************************************************************************/


//*******  Setup hardware pin definitions here ! ***************

//These are the pin definitions for one of my own boards, the Easy Pro Mini,
//be sure to change the definitions to match your own setup.

#define NSS 10                                  //select on LoRa device
#define NRESET 9                                //reset on LoRa device
#define RFBUSY 7                                //SX128X busy pin 
#define DIO1 3                                  //DIO1 on LoRa device, used for RX and TX done 
#define LED1 8                                  //On board LED, high for on

#define LORA_DEVICE DEVICE_SX1280               //this is the device we are using


//*******  Setup LoRa Test Parameters Here ! ***************

//LoRa Modem Parameters - relay listens on these parameters
const uint32_t Frequency = 2445000000;           //frequency of transmissions
const int32_t Offset = 0;                        //offset frequency for calibration purposes
const uint8_t Bandwidth = LORA_BW_0200;          //LoRa bandwidth
const uint8_t SpreadingFactor = LORA_SF12;       //LoRa spreading factor
const uint8_t CodeRate = LORA_CR_4_5;            //LoRa coding rate

//LoRa relay re-transmitts on these LoRa Modem Parameters
const uint32_t RelayFrequency = 2445000000;      //frequency of transmissions
const uint32_t RelayOffset = 0;                  //offset frequency for calibration purposes

const uint8_t RelayBandwidth = LORA_BW_0400;     //LoRa bandwidth
const uint8_t RelaySpreadingFactor = LORA_SF7;   //LoRa spreading factor
const uint8_t RelayCodeRate = LORA_CR_4_5;       //LoRa coding rate


const int8_t TXpower = 10;                      //LoRa TX power in dBm

#define packet_delay 1000                       //mS delay before received packet transmitted